The Yale GLP050VX is a trusted internal combustion forklift used in warehouses and industrial yards.
It supports medium to heavy lifting jobs and is designed for both indoor and outdoor use.
This model features advanced systems that improve load handling and operator safety.
One of these advanced systems includes built-in sensors to monitor real-time movement.
Among them, the toss sensor plays a key role in ensuring proper mast positioning.
What is a Toss Sensor?
The toss sensor is also known as a mast tilt sensor or tilt angle sensor.
Its job is to measure how far forward or backward the mast leans.
This helps the forklift controller prevent unsafe driving with tilted loads.
It ensures the mast stays within safe tilt limits during operations.
Without it, the forklift could tip or handle loads in an unstable way.
General Area of the Toss Sensor
In the Yale GLP050VX, the toss sensor is usually installed near the mast.
More specifically, it’s close to the tilt cylinders at the mast base.
This is the area where the tilt motion begins and can be accurately tracked.
The sensor is placed in a protected but accessible spot to avoid damage.
It may be installed on the frame near the hydraulic system that tilts the mast.
Toss Sensor Location: Step-by-Step Spotting Guide
Start by turning off the forklift and securing it on a level surface.
Go to the front part of the forklift where the mast connects to the frame.
Look for the two hydraulic tilt cylinders that push the mast forward and backward.
Check near their base pivot points for a small mounted device with wires.
That is usually the toss sensor—firmly attached and connected to a harness.
Electrical Connection and Integration
The toss sensor sends tilt signals to the forklift’s control computer.
This connection is made through a wire harness linked to the VSM (Vehicle System Manager).
The signals are either analog or digital, depending on the sensor model.
These messages help activate warnings or stop unsafe movements automatically.
If the wires are loose or damaged, you may see tilt-related fault codes.
Common Problems with Toss Sensor
Over time, the sensor can get loose due to forklift vibration.
Sometimes, wires around it may get pinched or melted near the engine heat.
Moisture or dust can get into the sensor if it’s not sealed properly.
Another issue is incorrect calibration, which causes the sensor to give wrong data.
In all cases, you’ll likely see a dashboard alert or system lockout.
Maintenance Tips
Inspect the toss sensor area during regular service intervals.
Clean away dirt, oil, or debris that may build up near the sensor mount.
Make sure the mounting bolts are tight and the wires aren’t frayed or pinched.
Use Yale-approved diagnostic tools to check sensor output and reset faults.
Replace faulty sensors only with genuine parts recommended by Yale.
Conclusion
The toss sensor in the Yale GLP050VX is vital for safe and stable operation.
It keeps track of mast tilt and helps the control system make smart decisions.
Located near the base of the mast, it must stay clean, secure, and well-connected.
Understanding where to find it makes inspections and repairs easier.
Routine maintenance ensures the forklift runs safely with fewer disruptions.
